Depending on the instrument the process will take from 5 minutes to 3 hours. If the proper bin file and instrument to PC connection is made the flash process will begin after one final confirmation. The first choice will be the COM port or the USB instrument followed by a selection for the. To begin flashing an instrument, use the Run menu Write to Device Flash option. An initial prompt is used to determine the interface between the PC and the host instrument. bin file from the products' embedded software page prior to running the WinFlash program. To upgrade a product you must download the corresponding. After the software is installed, launch the WinFlash program from the PC shortcut to run the program. Use the Custom installation option to exclude the PPC4 USB driver option because it will generate an error when using the Complete installation option. The installation program will prompt you through the installation process.

Download and run the installation program. Use the WinFlash 64Bit option for 64bit operating systems and use the standard WinFlash choice for 32bit operating systems. The flash process requires that the instrument be connected to the host PC via RS232. Review the details on the specific product download page to ensure that WinFlash is the proper tool to update the firmware. The *.bin files are located on the support firmware download page ». Use WinFlash to load a *.bin file to update the firmware of an instrument.

This program writes new releases of embedded software to the FLASH memory based products listed above.

PPC2+, PPC3, PPC4, PPCH, PPCHG, PPCK+, MFC-CB, molbox1, molbox1+, molbox RFM, PG7000, RPM3, RPM4, RPM4-AD, RPM4-AF, RPM4-E-DWTįirmware upgrade utility.

Ami winflash utility